Harman Stove Company R16 User Manual download pdf (Page 27)

XXV Pellet Stove

The glass in your Harman stove is a special ceramic

glass.

• Do not abuse the glass by striking or slamming the

door.

• Never burn the appliance if the door glass is

cracked or broken.

• Replace only with Harman supplied 5mm ceramic

glass.

Soot and/or y-ash may accumulate on the viewing

glass, and will ocassionally need to be cleaned. Clean

the glass with a soft cloth and mild glass cleaner. Do

not clean the glass when hot, and avoid the use of

abrasive cleaners.

Glass replacement

Carefully remove all remaining glass and gasket

materials prior to replacing the glass.

Lay the door face down on a at surface. Remove the

glass retainers and screws. Apply the gasket material

to the face of the new glass. Lay the glass into the

door, making sure that the glass is contained within



Pellet nes will accumulate in the feeder body over

a period of time; therefore, a yearly inspection and

cleaning of this must be performed.

To clean out nes:

1. Remove right rear cover panel.

2. Remove wing nut and feeder cover on the right side

of the feeder. See Fig. 43.

3. Use a vacuum cleaner to remove all nes.

4. Reinstall feed cover, wing nut, and right rear cover

panel.

Pellet Fines will build

up in this area

Feeder cover gasket

Feeder

cover

Wing

Nut

Fig. 43



Screws &

Retainers

Glass

Gasket

the channels and raised areas of the door itself.

Lay the glass retainers into position and install the

screws. Tighten each screw evenly to avoid making

any stress points.

Two 5/16" socket hex screws on each side.

Fig. 42

1 2 ... 22 23 24 25 26 27 28 29 30 31 32 ... 43 44

Comments to this Manuals

No comments

Harman Stove Company R16 User Manual Page 27

Comments to this Manuals