Harman Stove Company R16 User Manual download pdf (Page 18)

XXV Pellet Stove



   This setting, see above,

will produce a room temperature of 70 degrees with the

distribution blower at medium speed.

The XXV is a fully automatic stove that features

two operating modes;  and

  . In Stove Temperature

Mode, you select a burn rate and the stove will remain at

the same burn rate regardless of the room temperature.

In the Room Temperature Mode the stove constantly

monitors the temperature in the room and adjusts the

size of the re and the heat output of the stove so that

the room is kept at a constant temperature. Room

Temperature Mode, in the AUTO position, has the

added advantage of turning the stove off if no heat

is required and turning the stove on again when the

room temperature drops below your desired room

temperature set point.



Most consumers use the stove in the Room

Temperature Mode because it is the easiest and

most efcient method of keeping the room at a given

temperature. In the Room Temperature Mode, the

Room Sensing Probe constantly monitors room

temperature. As the weather changes outside and

your home needs varying amounts of heat to be at a

desired temperature, the stove will automatically adjust

size and heat output of the re so that a constant even

temperature is maintained. If the weather warms

up and no heat is required the stove will gradually

shut down. When the house cools down, the stove

will automatically bring the room temperature to your

desired setting

In the Room Temperature Mode you can select either

 for the  using the igniter

toggle switch. When the toggle switch is in the Auto

position the igniter, located inside the burn pot, is ready

to automatically light the re when required. When the

toggle switch is set to the Manual position, the stove

can be lit manually with either a gel or a wax type re

starter. (see lighting instructions on page 20.) With the

igniter toggle switch set in the Manual position the stove

will automatically adjust the heat output, but the stove

will not automatically shut down if no heat is required.

Instead it will go to its lowest setting and remain there.

The Manual position on the igniter toggle switch lets

you light the stove manually, should the igniter fail for

any reason. Secondly, if you are using the Harman

battery back up system the Manual setting will prevent

the stove from turning off and on during a power failure,

which will drain the back up battery, and possibly cause

damage to the back-up or the stove.

In the Room Temperature Mode, the distribution

blower speed can be increased or decreased by

adjusting the Room Temp/Off/Stove Temp dial between

L and H. As output of the stove increases, the speed

of the blower will increase automatically to ensure

that more heat is transferred out into the room. The

distribution blower will shut off as the room reaches

the set temperature, this will prevent overheating of

the room.



Fig. 20

    





    



1 2 ... 13 14 15 16 17 18 19 20 21 22 23 ... 43 44

Comments to this Manuals

No comments

Harman Stove Company R16 User Manual Page 18

Comments to this Manuals