Harman Stove Company TLC 2000 User Manual download pdf (Page 9)







       is a knob

located on the bottom door. Sliding the knob to the left pro-

vides less air for a smaller re. Sliding the knob to the right

provides more air for a larger re. When burning wood, this

knob should be all the way to the left, closed.



 are located

on each side as shown at left and on page 6. Both controls

should be adjusted equally. Air from these controls also pro-

vides a curtain of air across the glass to keep it clean. Move

the controls down for less heat and up for more heat. When

burning coal these controls should be in the down position.





Coal must have air coming up through the coal bed in order

to burn. Some air over the top of the coal helps burn gases. A

small amount of air enters the top of the coal re when the

wood controls are in the down position.

Wood burns with top or bottom air; however, top air com-

ing down across the glass to form an air curtain works best

and keeps the glass clean.

This is why it is recommended that the coal control be

positioned to the  for wood burning.



















Crumple up six to eight sheets of news paper and place

in the rebox. Next place pieces of dry wood 3/4 inch maxi-

mum diameter on top of the paper, Next place several 1"-2"

split pieces of dry wood on top, followed by a few 2"-3" split

pieces. Set the wood air controls at the maximum heat output

setting, all the way up. Place the knob on the bottom door to

the left. These settings will allow the glass to stay clean as

you build your re. The coal knob may be moved to the right

to speed the ignition process but the glass may get dirty.

Ignite the paper and allow the re to burn until a good

charcoal bed, 2"- 3" (50 mm - 80 mm) is formed; (You may

need to leave the ash door open a crack to get the blaze going

properly, but never leave the stove unattended with a door

open.) Add more wood to create a deeper charcoal base 3"

to 4".

Once the charcoal bed is established you may add a full

load of dry wood. After adding the fuel, leave air setting at

maximum for 5 to 15 minutes. Then, adjust the air controls

and blower speed for the desired heat output.

















1 2 3 4 5 6 7 8 9 10 11 12 13 14 ... 27 28

Comments to this Manuals

No comments

Harman Stove Company TLC 2000 User Manual Page 9

Comments to this Manuals

Related products and manuals for Stoves Harman Stove Company TLC 2000