Harman Stove Company HARMAN Super Magnum Coal Stoker Stove User Manual download pdf (Page 22)

Super-Magnum Coal Stoker Stove

Do Not Burn Wet Coal!

3-90-02702R4_08/12

C. Before Your First Fire

• Be sure the appliance is installed properly and

that all safety requirements have been met.

Pay particular attention to the clearances to

combustibles, oor protection and the venting

instructions.

• Test your smoke detector(s) and CO detector(s) to

the specications of the manufacturer.

• Double check that the ash pan and internal rebox

are empty.

• Be sure to read this entire manual.

D. Starting Your First Fire

1. With the mode selector in the "OFF" position, and

the Feed Adjuster NOT on "Test", plug the power

cord into a properly grounded receptacle.

2. Fill the hopper with DRY coal.

3. Place some coal on the burn grate, lling the valley

in the back.

4. Turn the mode selector dial to the desired mode.

If Room Temp is selected, be sure to turn

the temperature dial above the current room

temperature.

5. Fill the rest of the grates with a mixture of wood

pellets, rice coal, and starting gel.

6. Light the starting gel with a match, and close the

door.

7. Only after the ESP temperature increases, will the

feeder start operating to increase the re size.

NEVER APPLY STARTING GEL TO THE STARTING

MIXTURE WITHOUT THE COMBUSTION BLOWER

OPERATING.

WARNING

"NEVER USE GASOLINE, GASOLINE-TYPE

LANTERN FUEL, KEROSENE, CHARCOAL

LIGHTER FLUID, OR SIMILAR LIQUIDS TO

START OR "FRESHEN UP " A FIRE IN THIS

HEATER. KEEP ALL SUCH LIQUIDS WELL

AWAY FROM THE HEATER WHILE IN USE".

E. Fire Characteristics

After lighting the re, it will go through a few different

stages of appearance. First, because of the wood

pellets mixed in, you'll see mostly tall yellow ames.

As the wood pellets burn away, and some coal begins

to ignite, your yellow ames will shorten and mix with

blue ames. After the wood pellets are gone and the

coal is the only thing burning, you'll see mostly blue

ames, which can be invisible in a brightly lit area. As

the re settles in, you'll have about a two inch band

of hot burning coals running across the grates. With

a maximum temperature demand, the ideal feed rate

setting will put this band approximately 1-2 inches

back from the end of the grates. Allow at least an hour

of burn time between adjustments to the feed rate.

The setting above will produce continuous maximum heat output

with the distribution blower at full speed.

The setting above will produce continuous medium heat output with

the distribution blower at low speed.

1 2 ... 17 18 19 20 21 22 23 24 25 26 27 ... 39 40

Comments to this Manuals

No comments

Harman Stove Company HARMAN Super Magnum Coal Stoker Stove User Manual Page 22

Comments to this Manuals

Related products and manuals for Stoves Harman Stove Company HARMAN Super Magnum Coal Stoker Stove