Harman Stove Company TLC 2000 Stove User Manual download pdf (Page 12)

TLC 2000 Coal Stove

Gaskets

Gaskets are used on the doors and top lid of the TLC

2000. You must check these gaskets from time to time, and

replace them when necessary. The gaskets are made of fi-

berglass of different sizes (obtainable from Harman Stove

Dealer) and are fixed in place with a high temperature stove

gasket cement. To change a gasket, first remove the worn

fiberglass and clean the area with a wire brush. Also clean

any other surfaces that come into contact with the gasket.

Place a small bead of cement in the area under the gasket,

then press new gasket material into the channel; do not over-

lap the ends. Seat the gasket firmly by applying pressure

when possible; for example, after changing the door gasket,

close the door. Allow the cement to dry before using your

stove.

Gaskets are located:

On the doors to provide airtight closure.

On the lid.

Handle

The handle on the front door of your TLC 2000 is

attached to threaded shafts. After a period of time, you may

find that the front door does not close as firmly as when your

stove was new. This is due to a natural compression of the

gaskets. To tighten the seal, open the door and rotate the

handle one full turn counterclockwise or bend the latch plate

on the stove.

Blower

The optional blower on your TLC 2000 stove re-

quires very little maintenance. You should, however, keep

the air inlet and the motor free of dust and dirt.

1 2 ... 7 8 9 10 11 12 13 14 15 16 17 ... 20 21

No comments

Harman Stove Company TLC 2000 Stove User Manual Page 12