Harman Stove Company R6 User Manual Page 5

  • Download
  • Add to my manuals
  • Print
  • Page
    / 13
  • Table of contents
  • BOOKMARKS
  • Rated. / 5. Based on customer reviews
Page view 4
5
Venting
A combustion blower is used to extract the com-
bustion gases from the firebox. This causes a nega-
tive pressure in the firebox and a positive pressure in
the venting system as shown in fig. 4. The longer the
vent pipe and more elbows used in the system, the
greater the flow resistance. Because of these facts
we recommend using as few elbows as possible and
15 feet or less of vent pipe. If more than 15 feet of
pipe is needed, the diameter should be increased from
3" to 4" because a larger pipe causes less flow resis-
tance. Be sure to use approved pellet vent pipe and
wall pass through fittings.
Vent Pipe
Pellet venting pipe ( also known as PL vent ) is
constructed of two layers with an air space between
them. This air space acts as an insulator and reduces
the outside surface temperature to allow a clearance
to combustibles of only 3 inches. The sections of pipe
lock together to form an air tight seal in most cases
however, in some cases a perfect seal is not achieved.
For this reason and the fact that the Invincible RS
operates with a positive vent pressure we specify that
the joints also be sealed with clear silicone.
Outside Air
Outside air is optional except in mobile homes
and where building codes require. The benefit of
outside air is mainly noticed in small very tight houses.
To install outside air use 2" sch 40 plastic pipe
inserted through the back of the stove. The pipe
should be run outside and terminate 3 feet or more to
the side or below the vent pipe outlet. Never termi-
nate the outside air above the vent pipe outlet. From
the stove and through the wall the PVC must be kept
3" from PL vent pipe.
HRV
When installing in a house with a Heat Reclaim-
ing Ventilation System (HRV) be sure the system is
balanced and is not creating a negative pressure in
the house.
+ = Positive static pressure
= Negative static pressure
Fig. 4
Page view 4
1 2 3 4 5 6 7 8 9 10 11 12 13

Comments to this Manuals

No comments